Created: March 18, 2015
The faster you are able to accelerate, the quicker you’ll need to be able to modulate your speed or even stop. You’ll also want to improve the modulation of your braking power. Beyond merely stopping, the ability to finesse your brakes has a good deal to do with the quality of braking equipment that you are using. Here at Mini Mania, we have solutions for all your braking needs.
Created: February 01, 2011
Over 5 million Minis have been made, most of them before 1985 when front disc brakes were standardised. Previously, standard Minis were fitted with drum brakes all round, adequate in light traffic but prone to fall out of adjustment, not very progressive unless recently overhauled, and not up to the quick responses needed to avoid accidents in modern high-density traffic.
Created: December 09, 2009
When you apply the brakes, you feel a pulsation through the brake pedal and even the steering wheel. You wonder how the brakes and steering are interconnected and what is causing the pulsation. How can it be prevented, and how can it be corrected? And most important, is it a safety issue?The cause o..
Created: March 08, 2009
Question:"Im replacing my front wheel bearings on my 78 leyland. (drum brakes) I fitted the new bearings and seals and went to fit in the drive flange and i noticed the seal is too big to seal on the flange. Is there a sleeve or spacer that the seal seals on?"
Answer:"Yes there is a tapered collar ...
Created: March 18, 2005
Created: September 26, 2000
Hawk Brake has utilized world class technology to develop and manufacture superior disc brake and clutch materials for the Automotive/Racing industry. Hawk products include Ferro-CarbonTM, CarboticTM, Carbon-Carbon and full metallic disc brakes and clutches. Hawk Brake's persistent development of racing friction will not only set new standards, but will also greatly enhance the quality, performance and integrity of your racing programs!
Created: June 09, 2000
Over the years, many changes were made to Mini brake configurations. The manufacturers tinkered with the master cylinders and rear brake balance valve, and rear shoes and cylinders on many occassions, and did not necessarily write these changes into the official service manuals. As specific data on change points is found it will be added to this page
Created: February 16, 2000
From my time on the Internet it became apparent that in England there is an easy and inexpensive option to upgrade Mini brakes, thanks to their favourite donor car, the Rover Mini Metro.
Created: January 30, 2000
Carbon metallic pads will fade at high temperature if not fully bedded. Only fully bedded pads will provide fade-free high performance. For maximum efficiency, new discs are recommended. AP recommends that the pad be bedded with the actual disc on which it is to be used. A pad can be heat conditioned on any disc, but it must be run with a coated disc to perform (the pad coats of the disc during bedding in procedure).