5% Off with Coupon Code

800-946-2642
Shop by Car
Gearboxes
Gearbox - Common sources of problems
Created: October 28, 2002
A gearbox needs careful and proper attention when building it up. It's the knowledge of what to look for prior to and during the build that sets the 'professional' builders apart.
Created: December 04, 2001
A fairly crucial part of how the idler gear operates is its tolerances and running clearances. End float is a continual problem as folk often ignore it, and because many units left Rover with incorrect (usually too big) clearances.
Created: April 13, 2001
With the cost of new primary gears spiralling ever upwards, and the availability of good, serviceable used ones, fitting new bushes to existing gears is becoming a more common solution.
Created: December 01, 2000
Although not of immediate interest to many road-runners/street-burners, mainly accorded to the racing scene, it seems to be a perplexing problem to a very large number of folk around the world, and has burned up plenty of telephone time.
ENGINE TRANSPLANTS - gearbox information
Created: November 01, 2000
Selecting the right final drive ration is a subject worthy of an entire book to explain the whys and wherefores, and also causes much consternation on the part of the transplanter. Much confusion’s spread over which gearbox has the best ratios, is best to use, and with which FD. For a detailed account on this and covering all gearboxes fitted as standard to the Mini, see the relevant separate articles 'Gearbox - Standard production gearbox types'.
GEARBOX - Close-Ratio Conversion Pre-A+ gearbox
Created: October 26, 2000
It is entirely possible to change the common 4-syncro gearboxes to the helical close-ratio set-up as used in the Cooper S, 1275GT, 1300GT, and some early MG Metros providing the right parts can be sourced.
Created: October 26, 2000
The final drive gears are ultimately responsible for the way your Mini goes after engine, gearbox, and under carriage tweaking has been applied. The aforementioned and the degree to which it has been done will affect the decision as to what Final Drive is required. They’re also responsible for much discussion between many tuning freaks, and confusion to the less informed.
Created: October 26, 2000
As outlined in the 'Gearbox - standard production gearbox types' article, it is entirely possible to change the common 4-syncro gearboxes to the helical close-ratio set-up as used in the Cooper S, 1275GT, 1300GT, and some early MG Metros providing the right parts can be sourced. And you don't already un-knowingly have the close-ratio kit fitted! Part numbers are detailed at the end.
Created: October 16, 2000
Modified engines producing more power generally induce owners to drive with greater verve, particularly when competing in one of the many motorsport disciplines. In fact this isn’t isolated to modified Minis. Owners of relatively standard machinery competing in a discipline or merely out on a country lane blast are subject to the same determination.
Created: October 16, 2000
Fitting an LSD isn't as simple as replacing the diff cage unit. In all cases a certain degree of diff housing modifications is needed - material needing to be ground/filed away to provide clearance for larger diff housing cases and crown wheel bolts. Although it has to be said the Quaife diff is supposed to fit without these mods. I've never found that.
New design of C-AHT54 Central-oil pick-up pipe - the reasons why.
Created: September 28, 2000
For years there’s only been one type of COPUP commercially available, but recently Mini Spares has seen fit to produce a new and much improved version. This initially caused much apprehension as it was a far cry from the original Abingdon 'ST' design Perhaps the most voiced question was 'Why?