Magna Guard bonnet Stripe Installation

PRODUCT WARNING!

READ BEFORE APPLICATION

Magna Guard®  Stripes Installation Instructions:

1.      Make sure that hood is clean, dry, and perfectly protected with a good quality wax.

2.      Make sure that stripes are dust free prior to installation.

3.      Position stripes even with rear edge of hood.  Allow ½ inch from windshield washer nozzles and 9 inches from center of Mini crest.

4.      Do not allow water to be trapped under stripes.  Remove before washing vehicle and after exposure to rain.

5.      Dry and store stripes flat or on a magnetic, vertical surface (refrigerator, tool box) when not in use.

6.      Stripes may be trimmed with scissors to fit early (non-BMW) Minis.

Dames & Associates L.L.C.

602.866.7776

Installation Tip:

The stripes will better conform to the curve of the hood (bonnet) if applied warm.

Article Date: Jun 28, 2006
Car Accociations: NEW_MINI
Hits: 5432