Wheel pitch after stud replacement
Created by: jjules
Orig. Posting Date | User Name | Edit Date |
May 26, 2022 02:07AM | jjules | |
May 25, 2022 03:38AM | 6464s | |
May 24, 2022 04:48PM | jjules | |
May 23, 2022 06:23PM | 6464s | |
May 23, 2022 09:58AM | jjules |
Total posts: 3
Last post: May 26, 2022 Member since:May 30, 2021
|
Cars in Garage: 0
Photos: 0 WorkBench Posts: 0 |
I did that and checked for any “wobble “ or other movement, i also was able to pull off the drum and check, all good with the hub. I took the spacer off and drilled out the holes to 1/2, replaced everything and took a digital measurement…less than 1 degree difference!
back to driving!!
back to driving!!
Total posts: 493
Last post: Mar 26, 2024 Member since:Jan 25, 2017
|
Cars in Garage: 0
Photos: 0 WorkBench Posts: 0 |
OK. If you jack the mini up with wheel on, turn the wheel 180 degrees ( bottom to the top) What happens?
Total posts: 3
Last post: May 26, 2022 Member since:May 30, 2021
|
Cars in Garage: 0
Photos: 0 WorkBench Posts: 0 |
I haven’t been able to pull the drum and check the hub, but it all looked good when i reinstalled..i did torque the castle nut to 60 foot pounds a it said to in the manual…i also did notice that the spacer rocked lightly while I was tapping it back in…i it possible I need up the studs somehow?
Total posts: 493
Last post: Mar 26, 2024 Member since:Jan 25, 2017
|
Cars in Garage: 0
Photos: 0 WorkBench Posts: 0 |
1st pull your brake drum and look at your hub. Is the hub sitting squarely on the stub axle? Did you torque the nut?
Total posts: 3
Last post: May 26, 2022 Member since:May 30, 2021
|
Cars in Garage: 0
Photos: 0 WorkBench Posts: 0 |
Hi All, Question for your brilliant minds,
Ive replaced the drivers rear studs from standard to 78 mm ones to be able to use a spacer( i had rubbing on the shock and tire). After reassembling the hub, brake drum, etc… the wheel is now pitched at about 4 degrees….what did i do wrong?
I’m very new to working on her and I have to teach myself everything, i appreciate the knowledge here!
Ive replaced the drivers rear studs from standard to 78 mm ones to be able to use a spacer( i had rubbing on the shock and tire). After reassembling the hub, brake drum, etc… the wheel is now pitched at about 4 degrees….what did i do wrong?
I’m very new to working on her and I have to teach myself everything, i appreciate the knowledge here!