STEP 1: TOOLS NEEDED: HAMMER, DOWELL REMOVER, WRENCH SET, TABLE PRESS, TABLE VICE AND TORQUE WRENCH

STEP 2: REMOVE STOCK DIFF FROM TRANS

STEP 6: REMOVE GEARS FROM DIFF AND INSPECT TRUST WASHERS

NOTE: REPLACE SIDE WASHERS IF NEEDED AND REMOVE BIG GEAR WASHERS COMPLETELY.

STEP 9: PUT SPIDER GEARS BACK INTO PLACE

STEP 10: INSTALL 1ST PHANTOM GRIP DISC PLATE INTO DIFF WITH SPRING SEATS FACING UPWARD

STEP 11: PUSH DIFF PIN AND DOWELL BACK INTO PLACE

STEP 12: PLACE SPRINGS INTO SPRING SEATS OF DISC PLATES

STEP 14: RE-INSTALL TOP HALF OF DIFF USING A TABLE PRESS

STEP 15: TORQUE DIFF BOLTS TO VEHICLE MANUFACTURER SPEC AND YOUR PHANTOM GRIP IS READY FOR USE.