PHANTOM GRIP LIMITED SLIP DIFFERENTIAL
CLASSIC MINI BASIC INSTALLATION INSTRUCTIONS


KIT INCLUDES 2 DISC PLATES, 4 GOLD SERIES SPRINGS, INSTRUCTIONS, AND 2 STICKERS
Click photos for larger image
 

STEP 1: TOOLS NEEDED: HAMMER, DOWELL REMOVER, WRENCH SET, TABLE PRESS, TABLE VICE AND TORQUE WRENCH

STEP 2: REMOVE STOCK DIFF FROM TRANS

 
STEP 3: SECURE DIFF IN TABLE VICE AND REMOVE DIFF BOLTS  
STEP 4: REMOVE DOWELL PIN AND DIFF PIN  
STEP 5: INSPECT DIFF PIN AND REPLACE IF NEEDED  

STEP 6: REMOVE GEARS FROM DIFF AND INSPECT TRUST WASHERS

NOTE: REPLACE SIDE WASHERS IF NEEDED AND REMOVE BIG GEAR WASHERS COMPLETELY.

 
STEP7: CHECK FOR CASTING FLAWS IN DIFF CASE  
BAD CASTING: GOOD CASTING
STEP 8: REMOVE CASTING FLAWS WITH DIE GRINDER  

STEP 9: PUT SPIDER GEARS BACK INTO PLACE

STEP 10: INSTALL 1ST PHANTOM GRIP DISC PLATE INTO DIFF WITH SPRING SEATS FACING UPWARD

STEP 11: PUSH DIFF PIN AND DOWELL BACK INTO PLACE

STEP 12: PLACE SPRINGS INTO SPRING SEATS OF DISC PLATES

 
STEP 13: PUT 2ND DISC PLATE ON TOP OF SPRINGS  

STEP 14: RE-INSTALL TOP HALF OF DIFF USING A TABLE PRESS

STEP 15: TORQUE DIFF BOLTS TO VEHICLE MANUFACTURER SPEC AND YOUR PHANTOM GRIP IS READY FOR USE.

STEP 16: COMPLETE