× 1-800-946-2642 Home My Account Social / Forum Articles Contact My Cart
Shop Now
Select Your Car Type Sale Items Clearance Items New Items

Alloy vented brake conversion kit, only for use on existing caliper type hubs as used on Cooper 'S', 1275GT and all Classic Minis from 1984-on. Requires 12" or 13" wheels to fit. The calipers are the alloy 4-pot type as opposed to the cast factory type calipers.

Also see kit C-AJJ4029A for the full kit including front disc brake hubs, roller wheel bearings and driveshaft CV joints when changing from early Classic Mini drum brakes.

Brake Conversion Kit Alloy 4-pot Caliper Vented Disc | Classic Mini

Brake Conversion Kit Alloy 4-pot Caliper Vented Disc | Classic Mini

Brake Conversion Kit Alloy 4-pot Caliper Vented Disc | Classic Mini
Part No: C-AJJ4029
$953.95
Qty:
Specially Priced. Discounts Do Not Apply.
Fits the following:
Classic Mini

Alloy vented brake conversion kit, only for use on existing caliper type hubs as used on Cooper 'S', 1275GT and all Classic Minis from 1984-on. Requires 12" or 13" wheels to fit. The calipers are the alloy 4-pot type as opposed to the cast factory type calipers.

Also see kit C-AJJ4029A for the full kit including front disc brake hubs, roller wheel bearings and driveshaft CV joints when changing from early Classic Mini drum brakes.

Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Related Technical Articles:
Classic Mini Cooper Brake Rotors & Drive Flanges page 9
Created: December 28, 2018
See our great selection of every Brake Disc (rotor) as used on the Classic Mini Cooper from 1959 thru 2000. Stock and high performance options for Rotors, Drive Flanges, CV Joints and Brake Pads.
Upgrading Classic Mini Brakes
Created: February 01, 2011
Over 5 million Minis have been made, most of them before 1985 when front disc brakes were standardised. Previously, standard Minis were fitted with drum brakes all round, adequate in light traffic but prone to fall out of adjustment, not very progressive unless recently overhauled, and not up to the quick responses needed to avoid accidents in modern high-density traffic.
BRAKES - Fitting discs and required ancillaries
Created: December 10, 2000
What you actually need for the disc/drum conversion is pretty straightforward. Disconnect the steering arms, top and bottom swivel-pins, CV joint, and flexible brake pipes at the subframe - that’s it. There are, however, a number of ancillaries to consider.
BRAKES - Fundamental considerations
Created: December 06, 2000
Most folks immediately turn to considering higher engine power outputs. Because of this pre-occupation brakes tend to slide down the improvements priority list. However, they are far more important...