Helps prevent tailgaters! This PULSAR pulser will get their attention! Third Brake Light PULSAR converts your 3rd brake light to 'flash' when first applied, greatly enhancing visibility to the car behind.

Fits the following models:

• 2002-2006 R50 MINI Cooper and R53 Cooper S Hardtop
• 2005-2008 R52 MINI Cooper and Cooper S Convertible

This 'Smart' PULSAR for LED or bulb based brake lights will flash (i.e. "pulse") your third center brake light when you apply your brakes and then brake light will remain on without flashing as long as your brake lights are on.

When in stop-and-go traffic, SmartPulse will stop the third brake light from pulsating. When you hold your brake pedal down for more than 12 seconds and then re-apply your brake within 9 seconds, this unit will not pulse the third brake light; it will come on solid. When you reapply your brakes after 12 seconds, the unit will pulse your third brake light again. If you do not wish to have the SmartPulse enabled, simply remove the jumper at J4 and the unit will behave like the standard PULSAR.

The 'Smart' PULSAR can be configured during installation to flash about 3 seconds when set to short pulses, and about 6 seconds when set to long pulses.

Using surface mount technology, this little unit was designed to be as small as they could get it for the MINI, and fits nicely into the third brake light cavity.

Unlike other units, this is silent during operation. No clicking!

Will this work on other cars? Yes, as long as they are 12V and have a third brake light. The 'Smart' PULSAR works with LEDs or incandescent (bulbs) brake lights.

• See instructions for 2002-2006 R50/R53 Hatchbacks and 2005-2008 R52 Convertibles here
• See instructions for 2007+ R56 Hatchback, 2008+ R55 CLUBMAN, and 2009+ R57 Convertibles here