which stick on was it? do you know if anything can quiet the pipes from the manifold? i was thinking maybe first wrap with the titanium manifold wrap then over that wrap lead

DEI product. I have used their products in several in places on my mini. Lined the underside of the tunnel with their stick on stuff, much quiter and cooler inside now.

Yep! they are there.

ok i drag and dropped the pics into the green circle and they were loaded under on left side, let me know if you see em

To post pictures, have a look at this thread.

https://www.minimania.com/msgThread/121074/1/1/How_do_you_post_a_picture

You may have to reduce your image file size before it will post - huge files are not accepted.

don't know how to post an image but the part is called versa-shield , company is DI design engineering inc., part number is 010908 versa shield 7" x 24" 

Do have a part number? Any pictures of the installation?

I'm just amazed at the knowledge of the board.

Thanks. It's fairly easy to boil the fuel in an HIF without a heat shield.

Kelley

its a Hif44, 1-3/4" with BDL needle, the manifold is the freeflow 

Just out of curiosity what carb(s) and intake manifold do you have on the car?

Kelley

solved, I bought a heat shied that is made to cover a starter and installed it just under the carb between the exhaust manifold and bottom of carb, it purs like a kitty

Check that the fuel line isn't running too close to the exhaust. You might have a mild vapor lock.

Kelley

it does the same thing at 1000rpm or 12000 , could it be the bimetal strip heating up and changing the mixture? cause it only starts happening while at idle after a good 4 mile warm up run

Increase the idle rpm ... 800 is too low.

my 69 MKII coopr s 1275 has pertronix 2,  idles ok until i take it for 4 mile fast run then when at idle after 2 minutes starts to sputter couple times towards stalling every 4 seconds, can't idle smoothly at 800rpm , I tried everything, new plugs/wires/distributor/coil /fuel pump/vacuum pump on/off, dash pot oil, fuel mix/ choke/  timing / air filter, checked hoses, checked for leak with wd40, fuel filter, any ideas?