× 1-800-946-2642 Home My Account Social / Forum Articles Contact My Cart
Shop Now
Select Your Car Type Sale Items Clearance Items New Items
Free Dashcam - Click Here for More Info!
Outer support bearing for the first motion shaft. Comes with bearing and outer race. You must replace the outer race when using the new bearing. An easy way to remove the old race is to clean the housing very well, remove the circlip, and place the whole housing in the oven at 300 degrees for 10 minutes. Upon removal, slam the housing, engine side down, onto a flat piece of wood and the race should fall out. This is also a good time to install the new outer race. You can freeze the new race to make it that much easier.
Classic Mini bearing 1st motion outer

Classic Mini bearing 1st motion outer

Classic Mini bearing 1st motion outer

Classic Mini bearing 1st motion outer

Classic Mini bearing 1st motion outer
Part No: AAU8424
$28.95
Qty:
Fits the following:
Classic Mini
PayPal Pay Later
Alternate Products
Classic Mini Input Gear Bearing Outer Support RHP Type Made In The Uk
$70.95 Classic Mini Input Gear Bearing Outer Support RHP Type Made In The Uk
Outer support bearing for the first motion shaft. Comes with bearing and outer race. You must replace the outer race when using the new bearing. An easy way to remove the old race is to clean the housing very well, remove the circlip, and place the whole housing in the oven at 300 degrees for 10 minutes. Upon removal, slam the housing, engine side down, onto a flat piece of wood and the race should fall out. This is also a good time to install the new outer race. You can freeze the new race to make it that much easier.
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Related Technical Articles:
Classic Mini Cooper Transmission Bearings page 44
Created: December 21, 2018
View the selection of Gearbox gearing for the Classic Mini Cooper from the Mania Catalog as a PDF. Find a Part No. in the catalog. Type or copy/paste it into the search box to find it on the website.
Classic Mini Idler gear - Setting end float
Created: December 04, 2001
A fairly crucial part of how the idler gear operates is its tolerances and running clearances. End float is a continual problem as folk often ignore it, and because many units left Rover with incorrect (usually too big) clearances.