× 1-800-946-2642 Home My Account Social / Forum Articles Contact My Cart
Shop Now
Select Your Car Type Sale Items Clearance Items New Items
Free Dashcam - Click Here for More Info!
Lower suspension arms to give 2.5 degress of negative camber. Sold in pairs only.
If you are driving your car very hard and want to insure it will corner at your speed you must pay attention to the camber of the front wheels. In stock form many Minis actually have 1/2 degree positive camber (top of the tire leans out). Negative camber is needed to make it handle. Our special cast 2 1/2 degree camber arms will be a direct replacement for the stock units and allow for installation without having to readjust caster! These arms can be install with either the stock rubber bush or a poly bush.
General:
Negative camber lower arms are specifically forged in different degrees to give 1.5 (C-AJJ3364), 2.0 (C-AJJ3364A) or 2.5 degrees (C-AJJ3364B) more negative camber. All are heat-treated and crack-tested for safety.
See C-AJJ3363 for adjustable lower arms, and C-AJJ 3365 for adjustable tie rods.
Alternate Products
Classic Mini Negative Camber 2 Degrees Lower Front Arm Pair
$132.95 Classic Mini Negative Camber 2 Degrees Lower Front Arm Pair
Lower suspension arms to give 2.5 degress of negative camber. Sold in pairs only.
If you are driving your car very hard and want to insure it will corner at your speed you must pay attention to the camber of the front wheels. In stock form many Minis actually have 1/2 degree positive camber (top of the tire leans out). Negative camber is needed to make it handle. Our special cast 2 1/2 degree camber arms will be a direct replacement for the stock units and allow for installation without having to readjust caster! These arms can be install with either the stock rubber bush or a poly bush.
General:
Negative camber lower arms are specifically forged in different degrees to give 1.5 (C-AJJ3364), 2.0 (C-AJJ3364A) or 2.5 degrees (C-AJJ3364B) more negative camber. All are heat-treated and crack-tested for safety.
See C-AJJ3363 for adjustable lower arms, and C-AJJ 3365 for adjustable tie rods.
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Related Technical Articles:
BRAKES - Fitting discs and required ancillaries
Created: December 10, 2000
What you actually need for the disc/drum conversion is pretty straightforward. Disconnect the steering arms, top and bottom swivel-pins, CV joint, and flexible brake pipes at the subframe - that’s it. There are, however, a number of ancillaries to consider.
BRAKES - Fundamental considerations
Created: December 06, 2000
Most folks immediately turn to considering higher engine power outputs. Because of this pre-occupation brakes tend to slide down the improvements priority list. However, they are far more important...