Created: October 09, 2018
Get ready for this Fall season with new brakes and lighting!
Created: July 31, 2018
Looking for Classic Mini Brake Parts? Did you know that in order to simplify your experience on our website you can browse Classic Mini parts by Subcategory. Brake calipers, cylinders, pads/shoes, brake kits and more. From your Mini experts at Mini Mania, since 1974.
Created: March 28, 2014
The rear suspension was even simpler than the front, as there are no half shafts to deal with.
Created: February 01, 2011
Over 5 million Minis have been made, most of them before 1985 when front disc brakes were standardised. Previously, standard Minis were fitted with drum brakes all round, adequate in light traffic but prone to fall out of adjustment, not very progressive unless recently overhauled, and not up to the quick responses needed to avoid accidents in modern high-density traffic.
Created: February 08, 2001
In 1992 I brought together a few friends to form what was soon called "The Alberni Valley Autosports Club" (AVAC). We had about 4 of us with one Austin Healy Bug Eyed Sprite, a Mini 1000 ("The No Brakes Mini), a Toyota Corolla and one rather worn out Datsun F10.
Created: December 13, 2000
The other 4-way valve on the bulkhead on later cars (part number FAM7821) is frequently wrongly identified as one of the above as they are similar. However, this unit does not have the electrical connection, and has a cylinder sticking out one end. This IS a brake pressure regulator, only fitted to front/rear split systems as far as I'm aware. The PDWA is built into the master cylinders in these applications.
Created: December 10, 2000
What you actually need for the disc/drum conversion is pretty straightforward. Disconnect the steering arms, top and bottom swivel-pins, CV joint, and flexible brake pipes at the subframe - that’s it. There are, however, a number of ancillaries to consider.
Created: December 08, 2000
You can only use the MS72 adjustable brake regulator/bias valve with a front/rear split system. Definitely NOT the diagonal split type (for identification see 'Brakes - Rear brake bias adjustment'). These should have been 'X-ed' at birth.
Created: December 06, 2000
Most folks immediately turn to considering higher engine power outputs. Because of this pre-occupation brakes tend to slide down the improvements priority list. However, they are far more important...
Created: December 06, 2000
Without a doubt the most important point to get sorted at the outset is just what makes brakes do their thing - FRICTION. The sole purpose of the brake set-up on any vehicle is to convert kinetic energy into thermal energy. In English that’s motion into heat - friction. The motion of the disc/drum across the surface of the pad/shoe produces a prodigious amount of heat.
Created: September 26, 2000
Hawk Brake has utilized world class technology to develop and manufacture superior disc brake and clutch materials for the Automotive/Racing industry. Hawk products include Ferro-CarbonTM, CarboticTM, Carbon-Carbon and full metallic disc brakes and clutches. Hawk Brake's persistent development of racing friction will not only set new standards, but will also greatly enhance the quality, performance and integrity of your racing programs!
Created: June 09, 2000
Over the years, many changes were made to Mini brake configurations. The manufacturers tinkered with the master cylinders and rear brake balance valve, and rear shoes and cylinders on many occassions, and did not necessarily write these changes into the official service manuals. As specific data on change points is found it will be added to this page