SU Twin HS2 Carb Linkage Kit
This fitting kit suits all later day HS2 and HS4 twin carb set ups where the balance rods between the carbs required are equal length(2.25"). Some early carbs had the balance bar with a triangular plate that were a shorter length. The kit has the original type abutment bracket that fits to the inlet manifold to guide the accelerator cable, 2 pairs of throttle and choke rod levers and a separate lever for the accelerator cable. The course thread UNC bolt is for the abutment bracket to manifold but will have to be shortened to the correct length for some late type manifolds.
Looking for a set of the throttle and choke linkage for SU HS2 carbs. Do you have things or a source for them?
Concerning the part no. MSSK9 (carburetor linkage). The balance rods for my set up look like they are different lengths than your kit state - 2.25”. One of my measurements is 3.25” and the other is 2.5”or 2.75”. Where is the actual measurement made to determine the length?
These are apx. 2.25" long
Spridget Mania Tech Team
The Spridget Parts and Accessories Experts