IMPORTANT NOTICE: Due to the COVID related issues your order may take longer than usual to arrive. Read More
We have detected you're not on the correct site for the car you have selected! Click the green button below to go to the correct site.
Select your car:
Created: January 27, 2014
Installing rings or pistons? We offer this almost fool proof means of installing your pistons with rings into the block. The hard anodized 6061 alloy has been precisely machined to virtually eliminate any chance of ring damage. Available for 1275cc pistons with +.020, +.040 or +.060 bore size as well as for 1360cc & 1380cc pistons.
Created: December 20, 2013
Small piston applications and availability have been changing over time
Created: September 21, 2010
The following chart shows the SAE recommended Automotive compression ring end gaps. These recommendations are followed for the majority of the ring line unless a certain application requires deviation from the chart.
Created: July 14, 2005
Pistons - Mega piston performance report The two other articles I have done on this site concerned what pistons are all about, different design and construction pros and cons, material specs, ring set-ups and so on. Under 'Pistons - Favourable features for maximum performance' it would seem that th...
Created: July 02, 2001
This is another of those subjects abused for ‘bar stool b*llsh*t’ one-upmanship. Ignorance is the main problem. Particularly as trying to get any really useful information out of the manufacturers concerned.
Created: July 02, 2001
The overriding factor that influences just what is best for an A-Series engine is the block's propensity for flex at higher rpm, and the crank's equal propensity for flex at the same sort of rpm levels. Both combine to require a piston that is as stable as possible to maintain effective and consistent ring-seal performance.
Created: April 07, 2000
When Omega quit making A-Series pistons, Mini Spares took it upon themselves to design and build a better Piston. Recruiting the AE Hepolite Group for their unquestionable and renowned design and manufacturing expertise, the goal was to produce the most robust piston possible given reasonable cost and weight limits. Applying current technological advances incorporating their very latest hi-spec AE109TF lightweight alloy and special double heat treatments, the result is an extremely durable piston that will withstand greater cylinder pressures at higher RPM than any other currently available.
Created: January 30, 2000
Over the years, there have probably been a dozen "stock" 1275 pistons. Currently, three different designs are available from AE/Hepolite as "stock" replacements. All have an 8.4cc dished top, but compression ratios are carried by changing pin height (Pin height is the distance from the top of the piston to the center of the wrist pin- see dimension "A" shown here).
Created: October 27, 2003
Below is a list of crankshaft identification data by forging or stamped numbers - yes, contrary to what many say/express, all cranks are forged. None are cast. They wouldn't last 2 minutes in an engine if they were cast - they'd be way too brittle. The differences are in the material used,...