× 1-800-946-2642 Home My Account Social / Forum Articles Contact My Cart
Shop Now
Select Your Car Type Sale Items Clearance Items New Items
Side entry distributor cap, as original. This cap fits all early cars with 23D/25D type distributors as found on the MK1/II Minis, all Morris Minor and early Sprites and Midgets. No tune up or trouble shooting is complete without replacing the distributor cap. Keep a spare in your car and on the shelf.
Classic Austin Mini Distributor Cap Side Entry For 23d And 25d (gdc102)

Classic Austin Mini Distributor Cap Side Entry For 23d And 25d (gdc102)

Classic Austin Mini Distributor Cap Side Entry For 23d And 25d (gdc102)
Selected: Side Entry Cap For 23/25D Distributors
Part No: DC1-DDB101
$21.98
Qty:
Fits the following:
Classic Mini
Sprite & MG Midget
Morris Minor
Alternate Products
Classic Mini Distributor Cap Top Entry 23d And 25d
$13.95 Classic Mini Distributor Cap Top Entry 23d And 25d
This is the replacement Powermax Red Rotor arm for the Powerspark PSD5 and PSD10 distributors.
This is the replacement cap for the PSD5 and PSD10 electronic distributors by Powerspark.
Top entry cap fits only later (post '74), Aldon distributors, and all A-Plus dist. w/points.
Top-entry cap takes plug-in wires and will interchange with DC1. The DC6 is much less prone to wet-weather problems.

This cap fits the early Minis that have a Pre A+ engine and use the Lucas 25D Distributor. Study the Technical information below to confirm exactly what you have, as many early models have been updated with later engines.

This rotor arm fits all A series electronic distributors when points are not fitted except for turbo --the distributor cap for this rotor arm is GDC156
For best performance the rotor should be replaced as often as the distributor cap. This rotor fits 23 & 25d4 distributors.
Finally a heavy duty red epoxy ignition rotor for the Lucas distributor DM2 , 22D4 , 23D , nad 25D . With todays high energy ignitions a heavy duty rotor is needed that will not ground through.
If you have a red distributor cap (GDC214) its likely that you have a Ducellier distributor and this is the rotor arm for it. Contact set is GCS2119 and the condenser is GSC2113
This was the first mini distributor cap to have screws hold the cap to the body from about 1990 on where electonic ignition was introduced ,therefore there are  no points or condenser but the rotor arm to use is GRA2143.Fits all 1992 onwards injection cars up until 1997. 
You cannot miss this red cap but it was only fitted to Ducellier type distributors.
Mini Rotor Arm, fits all Lucas Distributors post 1974 up until the introduction of Electronic (1992)

Rotor arm for GDC142 cap only. Not to be used with standard 45D distributor caps.

Related Technical Articles:
Classic Mini Spark Plug Sale
Created: July 01, 2019
We are having a SPARKLING SALE on select Spark Plugs & Components Check out the special LIMITED TIME ONLY savings on the parts below. STOCK UP AN SAVE!!
Classic Mini Cooper Distributors & tune-up parts page 46
Created: December 28, 2018
/Mini%20Mania%20Catalog.Distributors.46.pdf
Ignition Tune-Up Kits- classic Mini
Created: March 16, 2005
This visual guide will assist you in finding the right tune up kit for your Classic Mini!
Loading...
Loading...
Loading...