IMPORTANT NOTICE: Due to the COVID related issues your order may take longer than usual to arrive. Read More
We have detected you're not on the correct site for the car you have selected! Click the green button below to go to the correct site.
Select your car:
Created: March 28, 2014
The rear suspension was even simpler than the front, as there are no half shafts to deal with.
Created: February 02, 2011
This is one of those subjects viewed as a ‘black art’, largely because of lack of understanding and confusion. The confusion part is because folk encompass the whole suspension set-up deal with suspension arrangement and design, lack of understanding instilling terror at the thought of ‘fiddling’ with the suspension components.
Created: July 16, 2007
Mini handling is like a bottle of wine? It all depends on who is driving (or drinking the wine)! Experience, technique, expectations all result in a different formula for success.
Created: January 28, 2006
Frequently Asked Questions How do I adjust my rear telescopic dampers? There is a knob or a screwdriver adjustment at the bottom of each damper. If you turn the adjuster fully anticlockwise it will be on the lowest setting, then turn the adjuster clockwise - On our newer dampers there will be 28 points of adjustment and on our older dampers 14. You need to count the clicks, as once the maximum damping has been reached, the adjuster will keep turning. Always adjust both dampers an equal number of clicks.
Created: December 02, 2004
The principle behind a sway bar is to achieve a ‘balance’ to the car, front to rear, such that when we turn at our chosen speed we can maintain control of the car. As a Mini Cooper will naturally understeer in order to get closer to a balance, we either have to decrease the understeer or INCREASE oversteer.
Created: December 12, 2003
CASTOR/CAMBER GAUGE INSTRUCTIONS For all intents and purposes, this gauge can be considered a finely graduated plumb line - as that is exactly what it is! Before proceeding with any measuring for each factor, make sure the vehicle is on reasonably level ground without any wheel being in.
Created: July 11, 2001
The steady decline of readily available hydrolastic displacer units has prompted an escalation in the number of folk asking how to go about swopping from hydrolastic (‘wet’)
Created: February 27, 2001
A surprising number of racers still avoid dealing with them, as with geometry in general they're seen as another 'black art'. Not at all alleviated by the sight of the well-to-do single seater teams producing computer controlled, highly accurate scales to make last minute corner weight adjustments or slipping wafer-thin shims in between steering arms and hubs.
Created: October 09, 2000
This bar has been developed to complement those road cars fitted with post 1990 rubber springs. Being the softest compound yet used on the Mini in an attempt to improve comfort, they allow more body roll, thus compromising